Diesel Injector Fuel Injector 0445120191 Bosch for Mahindra Scorpio Pick-up 2.6 / SUV 2.6 Weichai Deutz Wp6

2. The spindle cover and the body are combined with rough plane, poor flatness, or bruises, or iron and garbage will be on the paper pad, then the iron and garbage should be removed, remove the point of the collision, coated with sealant assembly.

3. Large axial clearance of crankshaft. In order to ensure that the axial clearance of the crankshaft is in the qualified range, one is assembled after both sides of the paper pad are coated with sealant, the other is placed 0.2 mm thick paper pad at the shoulder blades of the two spindle tiles respectively, and the oil leakage problem can basically enshrouding.

4. Negative pressure of crankcase causes oil leakage of spindle cover. The cause of negative pressure should be found out and the vulnerable parts should be replaced.

5. The main shaft cover leakage or body oil hole drilling deflection, resulting in pressure oil leakage from the main shaft cover plane, then should be filled with the bulkhead and coated sealant assembly on the main shaft paper Hua.

Xii. Oil leakage from oil pump

Oil leakage is common in the inner hot sheet. Due to the high pressure of the new oil pump, the inner gasket is damaged or stained with garbage, which is most likely to cause oil leakage. Oil pump tightening bolt clamping force is not enough will also occur oil leakage phenomenon. The solution is to change the oil to break the paper. Tighten the oil pump bolts. The test proves that the oil pressure of S1100 engine without pressure reducing valve is 1.176 mpa (12 kg force) at 2000 RPM. Cm "), and the oil pressure of the reducing valve is usually 0.294 ~ 0.343 mpa (3 ~ 3.5 kg square/cm 3) at 2000 RPM.